Search results for query: *

Great response, I needed a good laugh today. I think a peep and forget it.

the original is 796626-2 the one I purchased is 728091

Greetings, I have a used Ithaca M37 20ga pump plain barrel. I purchased a used M37 vent rib barrel that looks exactly the same in every way, but it will not screw into the receiver. The age is middle 1960's gun and barrels. Any ideas on how the fit the new barrel?

Greetings, Has anyone tried the XS Sight Levergun rail system? It has the peep sights over a long scope rail. Seems like a good system to have peep sights for shorts distance, and a scope rail if you wanted to use for long distance or scout scopes. Any thoughts, Thanks

Thanks for the info-this site is great for info

Thanks for the replys, Do you have to drill and tap the receiver for the Williams sights. I have a 1975 model and the top is factory tapped. The front sight is .375 width and .504 height

I am a approaching the age 60 mark. The factory leaf sights on my Marlin 336 are getting too fuzzy to center the front sight to shoot well. I am looking for something better. I like the western look of the rifle without a scope. I have looked at Williams peep, Fire Sight, Lyman, and Skinner. Can...

Thanks

I am refinishing a older 1975 model Marlin 336. The butt cap under the lever, is it supposed to have the same finish as the stock or no finish at all. I want to put it back to original condition.Thanks

I am reworking an older 1975 model 336. Mine has the butt cap near the lever, does anyone know if the cap is supposed to have finish on it like the stock or is it just plain plastic with no finish?

Greetings, I am interested in starting a collection of 22 Revolvers. I have looked at the Colt New Frontier/Peacemakers, and the Ruger Bearcats and Single Six (old Models) Any other brands as collectable? Looking for advice, Thanks

Beeman P1 This was a great exercise in how to adjust a rear sight!

I have been asked to look at a Beeman P1 Spring Air pistol. My friend wants to know what is wrong with his shooting elevation. I tried the pistol and it shoots 4-5" high at 10 yards. I screwed the rear sight all the way to the bottom and that what I got, 4 to 5" low. Any ideas on how to fix the...

I think I want a Red Dot sight on my mini 14. Need help in choosing and mounts. Thanks in advance.

Remington 700 Thanks for the replies. THR is the best!

I have a Remington 700 BDL chambered in 7MM ultra Mag. I would like to rechamber the action to a Remington 308. Is the cost effective and can I do it?

Greetings, I am going with a one piece scope base. My question is what the heck is 20 MOA or regular. I have 223 cal. Do I need regular or 20 Moa base. Thanks for your help.

I just purchased a set of Talley Lightweight rings. The base and rings are made together. I may be just dense, but which way do you turn the rings, or does it depend on the need for eye relief? Any help appreciated.

Howa 1500 My rifle isa Howa 1500 SA 223. I am using a Swift 4-12x40. Like the idea of Picatany mount. Have a nice new set of Burris Signature mounts and bases, eye relief is just wrong for me.

Greetings, I have a Howa 1500 that I like very much. I wanted a good scope mounts so I purchased Burris turn in mounts with signature rings. What I am running into after mounting it is eye relief is not correct. I cannot bring the scope back far enough to get a full sight picture. Any idea on...