I have 3 vibrators, 1 ultrasonic and just bought a tumbler. I am trying to figure out how to remove the stainless pins when draining the cleaned batch. I bought a mesh colender, but the mesh is too large. It was the finest mesh I could find. I need your help.
I just bought an ultrasonic cleaner and a powder additive to make the solution. I ran a batch of brass throught 5 cycles off 480 seconds and did not see any difference. What do you use? PLEASE HELP!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.