Hi All,
Has anyone experienced any problems with CCI Blazer Brass .45 ammo? I recently bought a few cases of the ammo in .45 cal, and have had some issues with it chambering in all of my .45's. I also found 3 rounds out of 150 that had the FMJ bullet, seated much deeper in the brass case...
Anyone own a Sig GSR .45.? What is a good price for one, NIB. Also, what are the good/bad points of them.? "Thanks". BTW, this is not their new Revolution model.
"Semper Fi"
SILENT ONE
Hi all, I recently acquired a knife from an old lady in my neighborhood. I would like to find info about it. She said it was her grand fathers knife, and he carried it in W.W.-1 .It says US 1918 on the grip, and AU Lion, with a picture of a lion on the blade near where the blade joins the grip...
Has anyone purchased a K98-M48 series Mauser from Mitchells' Mausers', and what do you think of their quality ?. They are selling them in Gun List for $249.00. Also, can they be bought with a C&R FFL ?. Thanks for your help.:)
SILENT ONE
Say all,
I have a Colt 1911- A1 with a serial number, C 217xxx. I thought the highest number on commercial Colts was C 215018 when all colts were re-numbered to military numbers in 1942. They supposidly didn't start the commercial numbering again until 1946, with the numbers starting at C...
Hi ALL,
I recently acquired a used H&K P7-M8 squeeze cocker .9MM. What are your impressions of the weapon. I tested it on the range at 25 yds, and it is the most accurate .9MM I have ever fired. :D
Thanks for your help.
SILENT ONE
Hi all,
I'm curious as to which is the best overall recoil spring for .45 semi autos'.
I have some .45's from various manufacturers, and I shoot mostly 230 gr FMJ. factory loads. I bought some springs from Wolff in 16 , 17, and 18.5 lb rate. I am also going to start hand loading soon, and...
Hi all,
Finally going to start hand loading. What is the best and cleanest burning powder available for .45 acp? Also would like to know what bullets are best for .45's. Should I use round nose, flat point, or jacketed bullets?
Thanks for any help you can give me on this subject. Being a...
Hi all,
Do any of you know the value of a Beretta Desert storm mocel 92 FS?. I haven't seen one anywhere for quite some time.
Thanks.
Good Luck,and be safe.
SILENT ONE
Does anyone know if Colt C prefix serial numbers ended at the C 215xxx range, or did the numbers go higher?. Also were their any other contractors who used the C prefix in their serial numbers?
Thanks, I appreciate any help you can give me.
Good luck, and be safe.
SILENT ONE
Hi all,
I'm thinking of getting into hand loading. I have a lot of S&B brass that I have saved. I have heard their was a problem setting new primers in the pockets. Have any of you had problems with this? I shoot 230 gr FMJ and haven't had any problems with their factory loads. Any help would...
I'm curious as to how many of you own a S.A. Mil-Spec .45, and what your opinion is of them. I have two, and think they're great.
Thanks, and Be Safe
SILENT ONE
Just picked up my new springfield mil spec this morning. Brought it home , field stripped , cleaned and oiled it. Off to the range even though the temp here is 2 degrees above 0. Should be interesting to see if the lube turns to molasses. At any rate I'll post a range report when I get home and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.