Search results for query: *

Just a quick question on using this bullet designed for the .303 as a borerider in the 06. Unsized the driving bands are at .315 and the nose at .303 and it's a long nose. Sized down I've shot them subsonic with Trail Boss but I'm curious on both reduced loads of 4895 and the 16gr of 2400...

A friend recently gave me a JC Higgens model 583.23 bolt action 12 This is a Hi Standard from what I can find and even though out of the recall range by model number, it has the same defective bolt stop and was probably recalled also...This was done by sending in the bolt for a refund leaving...

I can find data all around the 7.7 but for the life of me can't find any data for Re15 in the 7.7. We're using reformed milsurp 06 brass and I've read I can use the 303 British as a starting point but I thought I'd ask the experts.... Someone here has to have used Re15 in the 7.7...

My brother borrowed it to load some 308win CB and dumped a soda on it in the process.... of course it landed on my fav load for the 160g #301618 on page 185...... I'm hoping someone can help me out as he actually ripped out the section listing the powders trying to dry it so I need the...

I got my lee mold a while back and have been experimenting with slugs since.... I just picked up the STI roll crimp tool and it works great, nice tight crimp, shoots well,,impacts the slug a touch but as I'm casting with dead soft lead it really doesn't effect it except for a ring in the slug...

well after reading Hogdon's pdf on light loads using Trail Boss in any cartridge, I finally picked up a can and using the ratio they listed of 100% load density and starting at 70% I measured the case then weighed a charge...7.8 grains with the 255 Keith boolits I'm loading in my 25-5 for 100%...

I started a thread a while back in smithing and found no answers so I thought I'd try a more widely read sub forum. We have a problem with a Marlin 20a pump .22 The rifle was purchased missing some parts including the magazine spring (of course the seller assured my brother she was a great...

My brother recently purchased a Marlin 20a pump .22 that was missing some internal parts. We've figured out some of the problems and have installed new firing pin, ejector and are working on the cartridge guide assembly and the magazine. Our problem is the schematics I have found are very...

I've a early '90's iirc springfield armory that just crunchs the heck out of brass. I use mil surp hardball and it feeds and shoots fine with an occasional stovepipe but a lot of the brass is left unusable. Any pointers on where to start looking? I've read the 1911 stickies but maybe I just...