Search results for query: *

I had always thought Dillon Precision, was unbeatable with their customer service, 10 days ago I emailed RCBS about a 41mag die, mine would not hold a decapping pin any longer, They responded the next day and today a new decapping unit and 5 pins arrived at N/C. Two weeks ago my Smith & Wesson...

I am loading light 44mag loads, 240 LSW with 5.5gr of titegroup, would it be safe to use large pistol magnum primers for this load?I have a few thousand of these in my stash and I am starting to run low on large pistol primers. I use this load for plinking and just fun shooting.

I have about 750 pieces of new 44mag brass, I find the listed loads abusive for plinking. Can I safely load the brass with 44special loads, I currently cast my own 430 240 grain SWC, The load I use for 44 special is 4.7 g of titegroup, the recommended load starts at 9.0 grains for 44 mag. I...

I just started cleaning my brass with a Hornady ultrasonic cleaner. It does a great job especially on the primer pockets. I noticed that the flash holes in the primer pockets. on a large percentage of my 44 spec are ragged and enlarged, I have been hand loading for many years and have never...

I am about to start lead casting, my question is about sizing dies, do I use .452 for 45ACP, and .358 for 38 spec. I have ordered most of my equipment, I have 5000, 250 gr 45's that I purchase from National bullet in 1998. I was thinking of starting with these as my initial source of lead...

Been a member, and have enjoyed the information of probably the best gin site on line, I did not realize until today that I was able to contribute a small donation very easily to this wonderful forum, I received a reply from RADAGAST to a S&W question & noticed the link at the bottom, Thank...

I am starting to collect old military weapons, I like to hand load for most every thing that I own. Can I use the same .311 bullets for both 303 British, and 762.54R. I am loading the 303 at present but have not set up for the Russian as yet, anyone have any advice?

Does an inexpensive 4 - 12 scope exist, I would like one for my 44 mag marlin.

Looking for load data for barnes XPB 225 grain in 44 special, would like to use in my Charter Bull Dog as a carry weapon.

UPS left a hour ago, unpacked my Timber Ridge Magnum Shootring bench, that I recieved from Cabela's. It exceeded my expectations and I would highly reccommend it to any one who is looking for a stable platform for shooting. The kicker was that it is on sale for only $114.95. My back yard...

I am sitting with 1500 pieces of lead bullets .451 250 gr. I need a good load for my 45acp 1911's. I would use it for plinking. I'm setting up a steel gong in my back yard.

wrong post

I have been handloading for many years, I have always been meticulous in my loading procedures. I have been asked by a few members of a hunting club, to handload custom rounds for them. I would be willing and would enjoy the opportunity since I am retired with too much free time. My question...

I have an older Chineese SKS imported by Norinco, I have noticed in the ads from Spotsmans, and Cheaper than dirt, Hi Cap Magazines, will the work as interchangeable or just replacing the 10 round internal mag, will the fit my gun

Recently moved, I can now shoot in my own back yard, I set up my 3 Dillon's as well as my Rock Chucker and T7, could not get my SDB to function properly, called the 800 number, in 5 minutes my problem was diagnosed and today just 2 days latter the parts arrived in my mail box at no charge...

Looking for a good load fo Berry;s 9mm 124gr hollow base flat point, to use for plinking. also need to know oal for the round.

I have come to realize that I no longer have the same strength, eye sight, stability, and comfort level that I have had in the past. I usually shoot 45acp, 10mn, and occasionally some 44, and 50sw. I started using a new CZ75b in 9MM and found that I don't tire, as easily I can place my shots a...

I own and use many handguins and rifles, also an old light 12 Broning A5. My eyes are not what they used to be, I feel that a Pump shot gun would be an excellent home defence weapon . Does any one have any suggestions?

Read an article and saw pictures of the new bright and shinny CZ75B, I own a few of the wittness clones as well as an old Jericho in 41AE. How does the CZ75B stack up, I do own and shoot a few of their rifles, The SS 75 looks as it would be a very attractive side arm with a lot of BLING...

I am looking for a light load for my S&W 41Mag Montain Gun. I have acquired 1000 215 gr LSWC, and have most powders available, I have tried Trail Boss, but too much smoke for the indoor range Any suggestions. Shot the gun today and it was very accurate at v25 yards with 16 gr 4227, But...