I took some scrap brass to a local yard, don’t remember the exact value difference but they paid more for decapped . Otherwise they needed to cook it in case of a live primer.
Saw an issue w/pre-applied thread locker that required exceeding the torque requirements of the fastener as the fastener was run into the threaded parts. We spent a fair amount of time gaging threads and checking torque wrenches before we figured out the real issue. Have been a little leery of...
I use this on a new holster, works well. Normally only have to apply when holster is new.
https://stonerholsters.com/leather-dressing?search=Holster%20dressing
Instructions
https://stonerholsters.com/holster-dressing-instructions
Had a finger in the open action of a buckmark to keep the cleaning rod from hitting the bolt. Patch was good and tight and when it decided to go it jammed my finger onto the ejector (stiff wire) which went in about 1/4”. Hurt like heck. Also when much younger got my left thumb too high with a...
There is a member sale forum on the CMP forum, check everyday, shooter grade carbines come up quite frequently.
http://forums.thecmp.org/forumdisplay.php?s=6369a43b2f20ca658ac095e52d2fce63&f=88
Must not have read all the instructions when I got my UpLula years ago, didn’t realize you could also unload mags with the little button until I saw the Amazon clone videos.
I had a hard time replacing a safety detent on a P938, had to keep the detent pressed down with a thin pocket scale and rotate the safety over the detent , pushing the scale out of the way as it rotated. 2020 hindsight, could have used a thinner (.010”) feeler gage in place of the scale. Did...
Link to the ATF Proposed regulation:
https://www.federalregister.gov/documents/2020/12/18/2020-27857/objective-factors-for-classifying-weapons-with-stabilizing-braces
Used the plastic anchors to install two of these on each side wall, cut shelves to fit snug between, so no loading to pull anchors. Allows adjustment of shelf spacing. http://mobileimages.lowes.com/product/converted/010254/010254011714.jpg?size=pdhi
I reworked a 12 gun safe into a jewelry safe for my wife. If you add shelf bracket tracks you will need to use plastic screw anchors, usually what is behind the carpet or fabric on the inside is gypsum board (drywall). MTM just came out with some neat plastic handgun boxes that stack and take...
Soaking overnight in kroil allowed removal. Now just need to order a new firing pin. New screw ordered, but recut slot in old screw so can reuse for now. Thanks for all the help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.