Search results for query: *

I´ve been waiting a long time for a highcap magazine for the Marlin. Has anyone experience with the 55rd or the 70rd drum? Do they work reliable or are they waste of time and money.

How do you carry additional ammo when you are out with your lever gun?

Win92 Trapper take down deluxe, 16" octagon barrel, .357 Mag, made by Miroku. I found one NiB for $1650, it seems to be a discontinued product and quite a bit rare but is it worth the money?

I am considering to replace my Rossi67 with a Winchester92 because i wanted one for years and now they are avaible in my area. Winchester 1892 Short .357 mag or Winchester 1892 Carbine .357 mag The main difference seems to be the rear sight, the saddle ring and the steel fore end cap /...

I have an 10 years old Glock17l, gen3, maybe 10k rounds through. It doesnt matter which brand of ammo i use, i get an occasional ftf (1-2 from 100rds). When i examine the round the primer is always hit but not deep enough to ignite. I cleaned the gun and noticed a broken spacer sleeve. I...

Is there a commercial mag extension avaible? I really like Marlin and i like 45/70, but the short mag tube with that long barrel looks awful.

I have 120 unfired R-P cases, but no rifle in this caliber. It seems to be nearly unknown over here. Do they have a value which makes it worth to keep them or should i bring them to the scrap dealer.

Im interrested in a new Marlin 1895SBL. Do they still have "issues" or can i buy one of the latest models without taking it to the next gumsmith ?

I want to load some .454 Casull rounds with a Sierra 240gr JHP Bullet and CCI SR Primers. Hodgdon has only Data for FA Bullets and Winchester SR Primers on their website. Id like to start 10% below the recommended starting loads with this unknown combination. Good Idea? Or should i stick...

Does anyone have good experience with this combination?

Is there an overview chart sorted by powders and their appearance such as ball, rods, plates?

I have occasinally failfire with my Springfield 1922M2. From 50rds 1 may not ignite at the first attempt. If i try the same round again it always goes boom. I tried Remington,CCI and Federal. May this caused by the rifle (firing pin, spring) or the priming charge of cheaper ammunition?

Maybe a stupid question, but how do i correctly use a diopter sight? I never used one before. I shot a Springfield 1922 in .22lr today at 50yrds distance. The groups were nice and tight but all far to high above. The slight on the right side with the scale showed 50yards. I think the sight was a...

I came across this rifles a small store. It is Good condition for $1600 from a decaesed collector . Is it worth the money? Are they really rare and hard to find? I have never seen one of these before.

Im thinking about getting a big bore lever gun. I have read alot bad reputation about Marlin since they have been sold to Remington. Due the fact i have nearly no chance to find a old Marlin whereon do I have to pay attention when I get my hands on a new Marlin ?

Which rifle would you recommend to meet the following specifications? .22lr bolt action 5+ round clip good accuracy made in USA or west Europe around $500

I am not looking for the best of the best, but it should fulfill the task it was purchased for. My limit would be $700. Any experience or recommendations ?

Any Savage 93 owners here? I am considering to buy this rifle for plinking, but i cant find information about the mounted scopes brand.

I have more than 500 WSP primers in stock which i bought years ago, but i still dont have use for them. Is there any safety reason why i should not use them with slow powders like H110 in .357 Mag? I could imagine that the powder may burn erratically any may cause a bad precision but that...

Simple question, is the Big Boss Press large enough to handle the .375 H&H Magnum cartridge ? I couldnt find any compatibility chart on their website.