Same here. Ive got over 15000 round on my spring with different calaber from 380, 44mag, 45, 223, 308 and 30-30. I tighten the crap out of the bolt then put the spring on. No problems knock on wood.
Thanks for your advice. Any more advice is greatly appreciated. I noticed that Remington discontinued the XHR. Anyone know why??
Bovice - I'm a Civil Engineer
sig, I'm not to worried about ammo because I reload.
Help me choose which Remington 700
I’m looking for a Remington 700 in 243. My LGS has a stainless SPS for $550 and a XHR for $690. I’m looking to punch holes in paper and to hunt with it. Any advice would be greatly appreciated. I don’t know much about either model other than they both had the...
Im looking for a press to reload 223 & 308, 30-06. I have a hornady lnl that i use for my pistols. im considering either single stage (forster) or a turrer press (redding). which do u recommend and why?
What else do I need to reload 223 Rem on my LnL?
-16 shell plate
-cci small rifle primers
-dies (not sure which ones yet)
-1000 pieces of brass
-TAC powder
-What about the powder station? do i need any thing? I usually buy the lower part of the powder drop so i dont have to set it up each...
I just purchased a Rock River AR15 and am looking for a die set. I was looking at the Lee 3 die deluxe set and the Lee Pacesetter 3 die set.
Any recommendations?
Don’t know how old my Glock (6years old ?) is but it bellied my brass badly. I replaced the barrel with an aftermarket one. No more worries and it still feeds reliably. Brass lasts longer too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.