Last trip out to the desert I tested wood penetration of 140 grain .36 conicals over 20.5 grains of Old Eynsford with a cereal box barrier between conical and powder loaded for a month. The results were surprising.
While freshly loaded conicals over 21 grains of 4f Goex penetrated 6 boards of...
After a few months of trial and error, I had the best full cylinder of shooting yet with the .36 Uberti London 51. 6/6 shots accurate with no cap jams, cap failures, or dropping loading lever (except after the last shot). This was with 23 grains of Goex 4fg under round ball in paper...
I recently discovered that Remington had made a .36 caliber revolver that was a lot like the .31 caliber pocket revolver. My question is were any of these at any point in the last few decades ever made by Uberti, Pietta, or other replica manufacturers?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.