Why or why not?
I see some manufacturers suggest it is good to do, to make sure cases are round as they may have been bent in shipping and handling.
What else do you do to "process" new brass?
A little background:
I reload cartridges in small batches (never more than 200 at a time; mostly 50 or 100) on a single stage press.
I prepare my brass through the priming stage, but may not load it until later. The reason is that I don't necessarily have the load I intend to use fully...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.