Since I haven't had anyone definitively explain to me how to bump the shoulder back other than what
the books that I have read and the videos I've watched and perhaps most importantly, me being an idiot, I'm not sure what is what.
Here's the problem. I use RCBS dies for resizing my .308 rifle...
Hello chaps
I have a reloading query here. I want to make 7.65x53 mauser (for the Argentine and Belgian Mausers) cases from a more available calibre. I tried using a Lee 7.65x53 full length sizing die on 30-06 cases and then trimming, but the resulting cases wouldn't chamber. I contacted Lee...
Dear guys,
I write this post referring to some Hornady Items: 480083 398067
These are the seating dies rubber flat washer, and the taper crimp seating O ring (not the ring below LNL Bush). #7 and #8 in attached Exploded
I am in Europe, here it is possible to find only one item (the flat...
I’ve got a set of RCBS 9mm Luger dies that I’ve also been using to load 9mm Largo, and rather than reset the dies every time I switch between them I’d like to find a spacer washer that I could put under the lock rings when loading the longer round. This is the same sort of spacer that’s usually...
Just getting into reloading 9mm and have a few basic questions.
Some of the brass I have is pretty nasty from being at an outdoor range. I picked it up knowing I was probably going to wet tumble and saw some before and after pics of wet tumbling with stainless media, so I picked it all up...
I recently ordered a 3 die carbide set from RCBS for .38 special and .357 magnum from amazon. I got the set in the mail today and was surprised to see that both the sizing and seating dies were labeled 380 AUTO. Upon further inspection I discovered that amazon (or someone, but I assume amazon)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.