neck

  1. H

    Need .223 Technical Support

    I have been reloading since 1977. I began reloading .223 Remington in 1979. I have used the same RCBS Reloader Special press since 1979. I have used the same RCBS dies (standard, not small-base) since 1979. They were last adjusted in 2016 to allow interchangeability between a Savage Axis...
  2. Toprudder

    Neck turning results - 223

    I thought I would take a stab at neck turning, to see if there would be any significant improvements. I purchased the 21st century tool, and I went whole hog and got the carbide cutter and nitride coated mandrel. I also got the matching neck sizing mandrel and die to complete the set. (I have...
Back
Top