oal

I'm looking for a relatively universal OAL for the RMR 115gr FMJ in 9mm. I only have a single barrel to plunk test against at the moment (Gen3 Glock) -- it will pass quite long. What is a good OAL for this bullet that would work with most 9mm pistols, including CZ and Gen5 Glock?

New here! Reaching out for help from some reloading experts. I have only been reloading for about 2 years. Just upgraded my press to a Dillon 750 with a bullet feeder. My issue is that I can’t seem to get it dialed in to get an appropriate OAL of my 9mm. Seems to be one of a few factors that...

As the title says, I'm doing some .41 special loads, and I'm finding conflicting information, especially regarding the OAL. I'm using Starline .41 SPL brass, and 210gr Berry plated flat point over 7gn of Unique. I found an article that said the OAL is 1.625" I think that's way too long. It's...

Good morning folks, Does anybody happen to know the nominal length for Hornady's 124 Gr. and 147 Gr. FMJ RN bullets? I can't seem to find it online anywhere. I'm just starting to work up loads for some RMR 124 and 147 Gr FMJ bullets (just opened the bags and measured some sample bullets this...

I'm having trouble getting consistent OAL on a Dillon xl650. Length of cartridge may vary from 1.175 to 1.131 when trying to seat a length of 1.125. I'm new to reloading. Any ideas what I might be doing wrong. Using mixed used brass fmj 115 gr 9mm.

Good afternoon everyone- I once again need your expert advise/opinions Here's my quandary: Old style 9MM .355 RMR 124 JHP Bullet length: .579 OAL 1.090 New 9mm .355 RMR In House 124 JHP Bullet length: .558 OAL ?????? Let me first say I will load both 1.090 and 1.069 to run across the chrono...

Ok guys, new member here and new to reloading... really new. I got me a press, some brass, some dies, bullets and all the fun stuff. Read a couple of books and searched all over the net for the last few months. BTW, just cause it's on the Internet does not mean its true... Here is my setup Lee...

Folks, New to reloading although learning alot quickly and new to the forum. I am probably 1000 rounds into reloading mostly 9mm so far and some .38 special about to get to .45. I am noticing my OAL vary from round to round always. I called hornady and they tell me this is normal on a...

Alrighty- Here's a question for all of you. Below is something that is very puzzling to me and I can't figure out. I am using a Lee Classic Turret. I have listed the empty case lengths and then the case overall length after loading with Berrys plated 115 gr. RN. Why such a variation...

Please bear with me as I am a newbie. I have a Lyman 49th reloading manual. When I look at the Caliber and the particular bullet I want to load, there is an OAL (Overall Length). Is that OAL the Minimum or the Maximum for that bullet or load? For instance the 40 S&W on page 362 of the...