I just reamed a LPP pocket on a single piece of 10mm brass down to an LRP with a pocket reamer, I wanted to see if my Glocks striker would be potent enough to set off these CCI magnum LRP's and after loading the empty casing with just the primer and dropping it into the chamber it fired but I...
After inspecting the cylinder throat diameters for variances on a 3 screw Blackhawk it became apparent that some changes will need to be made. I heard crickets after a previous inquiry pertaining to a reamer for this application, so I initiated the search. Manson units are listed at Brownells...
I am one of the die-hards still trying to make the 5.7mm Johnson (.22 Spitfire) round work.
The case is formed from .30 Carbine brass. The case is lubricated, run into a forming die that starts forming the neck. The case is then run into a trim die that also further forms the neck and then...
I've been looking around for a reasonably priced (~$100) finishing reamer for 7.62.x54R. Most places I've found seem to be out of stock and on back order. The only one I found in stock is at Brownell's was $142 + s/h. Anyone know of a source that has them in stock?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.