trimming

Hi guys, I am currently working on a handloading design project at university and would greatly appreciate your input into it. Are there any big, common problems you often encounter when Reloading/Handloading and using current presses, annealers etc.? As a team we are designing a modular...

Does anyone here use the Honey Badger trim adapter, and if so what can you tell me about it’s setup and use? Thanks!

Hey guys, So I was just at my reloading bench getting ready to load a ton of .224/5.56 rounds for an upcoming event. I haven't loaded this caliber in a while, and I was measuring my sized brass, with a wide degree of results. I know the trim length is 1.750", and the max case length is 1.760"...

Hey everyone just wanted to take a moment to talk about my newest purchase the little crow Gun works Worlds Finest Trimmer II so far I love it I’ve only used it once but it made short work of 50 pieces of 2x fired 6.5 Creedmoor I bought a small table top drill press from Harbor Frieght to...

Recently it came to me while mulling over the expenses of getting the .45 colt/.45 acp redhawk and eventually getting a .454 super red hawk cylinder for it, versus getting the super alaskan and eventually getting Hamilton Bowen to put a 4.25" standard redhawk barrel on the gun, that I could...