I bought a new ruger the other day and decided that today would be a good day to clean all the factory grease and grit off of it. I had some trouble getting the pins out to separate the trigger group from the receiver, I think the holes in the receiver were under sized or the pins were slightly oversized but just passed it off as factory newness.
I got the trigger group out and tried to remove the bolt buffer pin but it was stuck in there so hard that it would not budge. I was pounding that pin with a steel punch and a mallet for about 20 minutes and it would not budge. No matter how hard i tried it would not move an inch.
Any ideas how to get it out?
I got the trigger group out and tried to remove the bolt buffer pin but it was stuck in there so hard that it would not budge. I was pounding that pin with a steel punch and a mallet for about 20 minutes and it would not budge. No matter how hard i tried it would not move an inch.
Any ideas how to get it out?