greyling22
Member
So I've reloaded a couple thousand 30 carbine cases over the years with my lee dies, and they work.
But i was wondering if my sizing die is overworking the brass. look at this picture. From left to right I have a factory round, then 3 fired cases, then 3 resized cases, then one of my loaded rounds. My body taper just looks funny and nothing like a new or fired case.
The factory round measured about .337 in the middle. The fired cases about .349, and the resized ones about .336. so they seem to measure fine, they just look funny?
But i was wondering if my sizing die is overworking the brass. look at this picture. From left to right I have a factory round, then 3 fired cases, then 3 resized cases, then one of my loaded rounds. My body taper just looks funny and nothing like a new or fired case.
The factory round measured about .337 in the middle. The fired cases about .349, and the resized ones about .336. so they seem to measure fine, they just look funny?