.32 H&R mag load for 100 grain wadcutters

[Jason_W]

I recently picked up a Ruger SP101 in .327 federal and in anticipation of my first range trip, I wanted to load up some pleasant, inexpensive target loads in .32 H&R.

I invested in a few hundred cases and also ordered a bulk quantity of Meister hardcast 100 grain double ended wadcutters.

I can’t fond load data anywhere for wadcutters of that weight.

I was considering using load data for a 98 grain hollow base wadcutter as a starting point, but I I’m assuming the hollowbase is a noticeably longer bullet than the double ended.

Does anyone know of a manual or website that has load data for this bullet?

 

[ReloaderFred]

While the HBWC bullet is longer, it also allows more case volume due to that deep hollow base. You can use the same data for the 100 gr. DEWC as for the 98 gr. HBWC, as long as you start low and work up your load.

Hope this helps.

Fred

 

[Jason_W]

While the HBWC bullet is longer, it also allows more case volume due to that deep hollow base. You can use the same data for the 100 gr. DEWC as for the 98 gr. HBWC, as long as you start low and work up your load.

Hope this helps.

Fred

That’s encouraging. I have plenty of Red Dot!