robert garner
Member
hey all
I managed to break my cyl bolt, recieved replacement wont fit!
The hole is too small for the pin/screw .It may be EASIER to turn down the pin
however this doesn't seem the right course,so how to open the hole in the bolt,
without going too far or done too rough?
Which leads to second querry, afterputting revolver back together so as not to loose parts have noticed that the hand will OVER-ROTATE the cyl almost to point of being able to set hammer down on the safety pin 1/2 way to next chamber. I would imagine that this MAY have stressed the bolt as it would have been catching the cyl as it was still trying to rotate. Shorten the hand?
Thanks for your consideration. This is an older Uberti if that helps
robert
I managed to break my cyl bolt, recieved replacement wont fit!
The hole is too small for the pin/screw .It may be EASIER to turn down the pin
however this doesn't seem the right course,so how to open the hole in the bolt,
without going too far or done too rough?
Which leads to second querry, afterputting revolver back together so as not to loose parts have noticed that the hand will OVER-ROTATE the cyl almost to point of being able to set hammer down on the safety pin 1/2 way to next chamber. I would imagine that this MAY have stressed the bolt as it would have been catching the cyl as it was still trying to rotate. Shorten the hand?
Thanks for your consideration. This is an older Uberti if that helps
robert