StormTac
Member
I have a factory H&S stock on my REM 5R 308, and got tired of top-feeding rounds after shooting 5, so I installed a surgeon bottom metal on 3/4/11. Team Storm Tactical member Maciej has a full shop, and was kind enough to let me use his mill for an afternoon. It came out perfect, I didn't even need to bed it. I really like this bottom metal, and also like the one made by Seekins. They both have outstanding ambi mag realease systems and use AICS mags.
Note: If ordering a new Manners or McM stock, just have the factory do your bottom metal cut on the CNC machine. I did this one manually because its just a $200 stock I already had, and if it didn't come out right, it wouldn't be the end of the world. I have a Manners T4A on order and they are cutting my DBM at the factory on all my "nice" future Manners stocks.
Mark
Line up the new bottom metal by screwing studs into the action through the stock. I used a silver sharpie to show the lines on the black stock.
I started with the small 1/4" cutter to get the radius of the corners first.
Then used the bigger cutter for the straight passes, and larger radius.
Remove a little bit of material each pass, then shut off the machine and re-fit the DBM until its is perfect.
If you take your time and do it right, even a manual mill job can come out very nice and not even need bedding.
Run the bolt to make sure it locks without binding, and check trigger function dry, then ammo feed and eject rounds several times to make sure DBM is even and at proper depth. Safety on if possible when feeding live ammo. Re-mount scope and take it for a test drive at the range. This H&S stock has aluminum pillars already in it, so pillar bedding was also not necessary.
Note: If ordering a new Manners or McM stock, just have the factory do your bottom metal cut on the CNC machine. I did this one manually because its just a $200 stock I already had, and if it didn't come out right, it wouldn't be the end of the world. I have a Manners T4A on order and they are cutting my DBM at the factory on all my "nice" future Manners stocks.
Mark
Line up the new bottom metal by screwing studs into the action through the stock. I used a silver sharpie to show the lines on the black stock.
I started with the small 1/4" cutter to get the radius of the corners first.
Then used the bigger cutter for the straight passes, and larger radius.
Remove a little bit of material each pass, then shut off the machine and re-fit the DBM until its is perfect.
If you take your time and do it right, even a manual mill job can come out very nice and not even need bedding.
Run the bolt to make sure it locks without binding, and check trigger function dry, then ammo feed and eject rounds several times to make sure DBM is even and at proper depth. Safety on if possible when feeding live ammo. Re-mount scope and take it for a test drive at the range. This H&S stock has aluminum pillars already in it, so pillar bedding was also not necessary.
Last edited:
