I just picked this up as part of a trade. Why? I don't know, I guess it appealed to the walther ppk fan inside me. It's not walther sure, but the fit and finish isn't bad and it's pretty accurate with the wallyworld target loads I picked up.
However, the decocker does not always work (it does rotate the block up and safety the weapon but I have to use my thumb to lower the hammer), any ideas what might cause this? Functions fine about 75% of the time BTW.
I'd like to replace the grips too, but the only ones I have found for constables have a two screw setup per grip while this model only uses one per grip & a tab/hole attachment point at the base of where the two grips meet at the bottom of the backstrap. Any ideas on that?
Thanks!
However, the decocker does not always work (it does rotate the block up and safety the weapon but I have to use my thumb to lower the hammer), any ideas what might cause this? Functions fine about 75% of the time BTW.
I'd like to replace the grips too, but the only ones I have found for constables have a two screw setup per grip while this model only uses one per grip & a tab/hole attachment point at the base of where the two grips meet at the bottom of the backstrap. Any ideas on that?
Thanks!
Last edited: