MIL-DOT
member
I've had a stainless 6" GP100 for a couple years now, probably my favorite pistol. But a couple weekends ago, me and a buddy had two or three rounds not fire ( they fired OK on the 2nd try). These were Remington UMC from the wally world, first I've fired any Remmys through it ( mostly been Winchester & S&B ). Obviously, I'm considering it ammo related, but this pistol has a very light trigger, both single and DA. In fact, it's not uncommon for whoever fires it (me included) to prematurely send the first round downrange while sighting in, but once used to it, everyone loves it.
But my SP101 was so tight, I got a Wolff spring replacement kit and lightened the hammer spring. I'm wondering if I might should do the opposite with the GP100, and tighten it up a bit.
I'm also wonder, since they appear almost identical internaly,if I could use one of the springs from the SP101 kit ?
Any advice much appreciated...........
But my SP101 was so tight, I got a Wolff spring replacement kit and lightened the hammer spring. I'm wondering if I might should do the opposite with the GP100, and tighten it up a bit.
I'm also wonder, since they appear almost identical internaly,if I could use one of the springs from the SP101 kit ?
Any advice much appreciated...........