This may not be the correct thread but perhaps someone could point me in the right direction. I have a glock 10 with a ctc pistol grip laser. I lost the adjusting wrenches and am stuck. Does anyone know where I can buy another wrench and does antone know the size of those wrenches. I would really appreciate any info on this. Thanks.
glock 19 ctc laser
- Thread starter norman99
- Start date
- Status
Al Thompson
Moderator Emeritus
Hi Norman, welcome to THR! I'd call CTC and see if they would sell the wrenches. 
Blue68f100
Member
I will have to dig mine out. But was thinking they were a 0.030" or maybe 0.045" allen wrench.
rcmodel
Member in memoriam
Just measured mine at .028".
However, it's pretty unlikely you will find any that small locally.
If you call CT they'll send you the wrenches you need free.
1-800-442-2406
I also cut one off and epoxied it in a pen size dowel rod.
Then used a ball-point pin cover with a pocket clip that fit the dowell rod to cover it.
Much Harder to lose at the range or stab myself now!
rc
However, it's pretty unlikely you will find any that small locally.
If you call CT they'll send you the wrenches you need free.
1-800-442-2406
I also cut one off and epoxied it in a pen size dowel rod.
Then used a ball-point pin cover with a pocket clip that fit the dowell rod to cover it.
Much Harder to lose at the range or stab myself now!
rc
Last edited:
Blue68f100
Member
I have some white Electrical tape on mine so I can find it when I lay it down. Your right they are very easy to loose. I have a local Hardware store that carries them as well as an Industrial Supply house near me.
- Status