TheSandman1953
Member
- Joined
- Feb 9, 2018
- Messages
- 1
I have a H&R Model 922 Serial M61231, where the firing pin will not make contact. When I pull the trigger the hammer is about 1/8-1/16" short of making contact. When I depress the sear the hammer will close that gap but the pulling of the trigger does not depress the sear to make that contact. I see there are two types of sears for this model, one with a flat face and one with a rounded face that contacts the trigger. The one I have on the 922 is a flat faced sear... is it broken?
Is it a bad sear? Sear spring? Trigger? Any ideas?
Is it a bad sear? Sear spring? Trigger? Any ideas?