Mythdragon
Member
- Joined
- May 21, 2008
- Messages
- 4
I bought the Sig P229 Elite .40 cal.
I just bought a Sig (factory original ) 357 sig barrel.
However, when I install the new barrel the slide will not fully re-attach. It catches right where the takedown lever lines up with the slide-catch grove.
There are now dents and scratches on the bottom left and right sides of the feed ramp. Almost as if the feed ramp bangs against the slide somewhere.
Near as I can tell (aside from the barrel diameter) both barrels are identical in size. Side by side, I cannot see any obvious flaws. Why would one work, and not the other?
Is it more likely a bad barrel or a bad gun? And here I thought Sig was hi quality.
Appreciate any help.
I just bought a Sig (factory original ) 357 sig barrel.
However, when I install the new barrel the slide will not fully re-attach. It catches right where the takedown lever lines up with the slide-catch grove.
There are now dents and scratches on the bottom left and right sides of the feed ramp. Almost as if the feed ramp bangs against the slide somewhere.
Near as I can tell (aside from the barrel diameter) both barrels are identical in size. Side by side, I cannot see any obvious flaws. Why would one work, and not the other?
Is it more likely a bad barrel or a bad gun? And here I thought Sig was hi quality.
Appreciate any help.