sigma 40ve
Member
Just got a new in box P32, got it home and disassembled it. I immediately noticed a sharp groove worn in the top rear part of the frame on the side opposite the ejector. Also, there is what appears to be a piece at the front top edge on the same side that is damaged also. I found on the bottom of the slide a burr sticking out of a hole below the extractor causing the groove. I stoned off the burr. I have noticed that the extractor is hitting in the spot on the frame where it appears that a piece is missing, when the slide is pulled all the way back. Is this normal for the extractor on the P32? Also, is the Kel Tec quality control really that good if a pistol passed thru inspection with a burr causing a sharp grove in the frame?
Not trying to flame KelTec, I happen to have a P40 that I like. I am just concerned about what I saw on my NEW p32. Thanks for any replies
Not trying to flame KelTec, I happen to have a P40 that I like. I am just concerned about what I saw on my NEW p32. Thanks for any replies