Looking for a driver bit

[Mk-211]

Do they make a Phillips style bit without the point? Something with the four points of the phillips but the point machined off?

I think I've seen this style but not sure what it's called? I have some brass screws that I want to keep from getting damaged.

Having a better fitting bit that uses four points of contact instead of two, seems like a no-brainer.

 

[deadeye dick]

I think Reed and Prince is another style of cross tip and also metric might be different also.

 

[Mk-211]

Thank you, I will look it up.

 

[Blue68f100]

Make sure you use the proper size bit. If too small it will be loose. They also make a driver bit that it a cross between a phillips and square drive, which has a flat nose.

 

[Lo-Profile]

You can always remove the tip on a grinding wheel. I've done it before
Just don't let it get real hot