red rick
Member
- Joined
- Aug 11, 2009
- Messages
- 3,171
I just picked up my new plinker Wednesday and I have some concerns. While I was cleaning it, when I wiped down the the muzzle end of the barrel and back to the stock, my patched turned real brown the first time I cleaned it, that was Wednesday after getting home with it. I pulled it out of the safe today to go shooting and when I was putting the bolt in I noticed that there were a few tarnished places on the stainless steel part of the bolt, I got that off with some fine sand paper pretty easily. After that I wiped the barrel down again with a lightly oiled patch and it turned brown again, but not as bad as the first time. Do you think that it is rust and should I call Savage? There are know signs of pitting and the bluing is bright.
I don't think that the safe is doing this because I wiped down the rest of my guns today and the patches didn't turn brown and like I said it was like this before I even put it in my safe, I didn't notice the bolt discoloration then though.
My safe is 30 cu. ft. and I have a 18'' golden rod (200 cu. ft.), eva dry 300 dehumidifier (300 cu. ft.) and a safe dry II, 60 cu. ft. silica beads in it and I do recharge them regularly.
I don't think that the safe is doing this because I wiped down the rest of my guns today and the patches didn't turn brown and like I said it was like this before I even put it in my safe, I didn't notice the bolt discoloration then though.
My safe is 30 cu. ft. and I have a 18'' golden rod (200 cu. ft.), eva dry 300 dehumidifier (300 cu. ft.) and a safe dry II, 60 cu. ft. silica beads in it and I do recharge them regularly.