I picked up a Pelacan gun case a while ago and was wondering if you are supposed to cut all the way through the middle layer of foam or only cut 1/2" into the foam. Cutting all the way through the middle layer while leaving the others intact would be easier, but allow the gun some wiggle room. On the other hand, cutting only part way through the foam would be difficult do do cleanly.
Also, if I leave the foam uncut till I have time to work on it, is there any worry about damaging the hinges. I have to stand on it to close it when the foam is uncut.
Also, if I leave the foam uncut till I have time to work on it, is there any worry about damaging the hinges. I have to stand on it to close it when the foam is uncut.