igor
Member
The split tubular pin that holds the front of the Taurus' adjustable rear sight on the slide shook to bits several times. It was replaced the last time with a fitting piece of a drill bit and lok-tited in place.
The hard bit ate thru the top of the hole so that now there's a visible crack on the left side hole towards the top of the slide (in the, say, .7mm of metal there is...).
Anyone think there's a way to repair this? Or should I just go to the importer's for a new slide (this time a mod. 92 slide to avoid the whole rear sight fiasco :banghead: )?
The hard bit ate thru the top of the hole so that now there's a visible crack on the left side hole towards the top of the slide (in the, say, .7mm of metal there is...).
Anyone think there's a way to repair this? Or should I just go to the importer's for a new slide (this time a mod. 92 slide to avoid the whole rear sight fiasco :banghead: )?