Have a XL-650 set-up with subject die for 38 Special cause everybody says you have too have this die.
Now I wonder.................
The degree crimp you can apply with the Redding Profile Crimp is limited to how far you can screw it down until it contacts the shell plate. For those who are familiar with this set-up...........
1. What do you suppose is the degree of crimp that is being
applied to the cartridge case when the Redding die is at full
shell plate contact position, i.e. moderate, firm, crusher?
The Dillon die does not have a contact limitation and appears to be able to apply a much greater degree of crimp, though you may run out of lock nut thread.
Assuming the Dillon die is able to apply a much greater degree of crimp..........
1. What is it EXACTLY that makes the Redding Profile Crimp die
superior to the Dillon die?
2. Is the degree of crimp the Redding die is able to apply about
all you need even with the slowest of powders, and if yes does
it then come down to a more uniform quality crimp?
Inquiring minds want to know.
WESHOOT......just because is not a correct answer
TR
Now I wonder.................
The degree crimp you can apply with the Redding Profile Crimp is limited to how far you can screw it down until it contacts the shell plate. For those who are familiar with this set-up...........
1. What do you suppose is the degree of crimp that is being
applied to the cartridge case when the Redding die is at full
shell plate contact position, i.e. moderate, firm, crusher?
The Dillon die does not have a contact limitation and appears to be able to apply a much greater degree of crimp, though you may run out of lock nut thread.
Assuming the Dillon die is able to apply a much greater degree of crimp..........
1. What is it EXACTLY that makes the Redding Profile Crimp die
superior to the Dillon die?
2. Is the degree of crimp the Redding die is able to apply about
all you need even with the slowest of powders, and if yes does
it then come down to a more uniform quality crimp?
Inquiring minds want to know.
WESHOOT......just because is not a correct answer
TR