Cornhusker77
Member
- Joined
- Dec 20, 2008
- Messages
- 604
I'm probably missing something incredibly obvious, but I'll put my ignorance on full display and go ahead and ask.
The little flat spring that runs the bolt and trigger return broke, which I gather isn't that rare, so I ordered a Wolf spring from Brownell's.
When I put the new spring in and tighten the screw down tight, the hammer won't pull back, and the cylinder won't rotate.
If I back the screw out that holds that spring, even just a half turn, it frees things up and it works fine.
What am I doing wrong?
Thanks in advance.
The little flat spring that runs the bolt and trigger return broke, which I gather isn't that rare, so I ordered a Wolf spring from Brownell's.
When I put the new spring in and tighten the screw down tight, the hammer won't pull back, and the cylinder won't rotate.
If I back the screw out that holds that spring, even just a half turn, it frees things up and it works fine.
What am I doing wrong?
Thanks in advance.