Quantcast

USA1 Billet Toolheads for 550 Dillon

Discussion in 'Handloading and Reloading' started by Catpop, Feb 16, 2019.

  1. Catpop

    Catpop Member

    Joined:
    Dec 29, 2012
    Messages:
    1,907
    Location:
    Jack's Neck, NC
    Does anyone have experience using these USA1 non-Dillon toolheads?
    Any pros or cons?
    Is fit as good as factory Dillon?
    Thanks for help
     
  2. 300Whspr

    300Whspr Member

    Joined:
    Dec 16, 2015
    Messages:
    162
    Location:
    Southern Illissouri
    I don't have any of the USA1 toolheads, but I do have a few of the Jofer USA (also on eBay) toolheads. They are CNC machined from 6061 bar stock, and anodized. The OEM Dillon toolheads are cast aluminum.

    I would say that the aftermarket toolheads are probably higher quality than the OEM Dillon toolheads for about half the price.
     
    captain awesome and MikeInOr like this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice