spitballer
Member
The x-mark pro trigger on my Rem 700 ADL Varmint doesn't seem to adjust well anymore. I've reduced trigger pull a couple of times and each time it seems to revert to a hard pull after several dozen rounds or so. Breaks cleanly, just requires a lot of pressure. I've used Rem action cleaner, dried and added rem oil to the assembly as recommended but maybe there's a particular surface I need to pay attention to, or even carefully dress with a file. Anyone else have this trouble?
Or perhaps I've simply expected too much from this particular model assembly and adjusted the screw out too far: as best I can remember I've gone out about 1 1/4 turns from the factory setting. If anyone knows how many outward turns it has when it leaves the factory I could try starting over again from there and adjusting more conservatively...
Also open to suggestions for possible upgrade if necessary. This is a range-only rifle, a light trigger pull is a must. Thanks in advance for responses.
Or perhaps I've simply expected too much from this particular model assembly and adjusted the screw out too far: as best I can remember I've gone out about 1 1/4 turns from the factory setting. If anyone knows how many outward turns it has when it leaves the factory I could try starting over again from there and adjusting more conservatively...
Also open to suggestions for possible upgrade if necessary. This is a range-only rifle, a light trigger pull is a must. Thanks in advance for responses.