-
-
Aa5werkes reacted to Dave Markowitz's post in the thread Reinstalling the hand spring in a S&W revolver with
Like.
I was doing some work inside of a S&W Model 640 and the hand fell out (because I messed up). To reinstall it properly you need to remove... -
Aa5werkes replied to the thread Reinstalling the hand spring in a S&W revolver.I too do it in similar manner. For easy removal of the cylinder hand I use a small surgical skin hook tool to lift the spring limb up to...
-
-
Aa5werkes reacted to AzShooter1's post in the thread What gunsmithing or repairs have you done today with Like.
Cleaned my CZ 457 22lr. Had to use a. 17 cal rod and .20 brush and mops. CZ'S barrels are real tight. I also finished up by using my...
-
AIt came off. With the help of a pair of vice grips and 2 pieces brass from a .44 shell.And an idea from y'all. Thanks.
-
Aa5werkes replied to the thread Should be simple.I just deposited that idea in my data base. Thanks.
-
Aa5werkes replied to the thread Should be simple.Gunsmith is derived from the Latin word for "patience"....... A few minutes to construct a non-marring tool or use a polymer gripped...
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.Yes. The P225 was shorter profile single-stack 9mm derivative of the P220 .45. The P6 was a early derivative of the P225 with the...
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.For years, the Polizei relied on the P1 (Walther P38, .32 cal) P2 (SIG P210, 9 mm) P3 (Astra 600) service pistols, until the...
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.This is a full-circle Sig P6 story. I acquired both a Sig P225 and its specialty variant the P6 in pristine form many years ago. The P6...
-
-
Aa5werkes replied to the thread AR-15 Gas key screws sheared.I bet it does. I have a gauge to specifically check that gas key - lower receiver ring gap tolerances. A fancy two quarter test. There...
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.^^That's a lot of elbow energy!
-
Aa5werkes reacted to Armorer 101's post in the thread What gunsmithing or repairs have you done today with Like.
Did some sanding on the new stock for the 358 Win conversion. Have the metal work done, inletting and glass bedding done, just need to...
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.Yesterday, making a lathe center gauge for aligning 60 deg tool bit for single point thread fabrication. I have the Browning & Sharpe...
-
-
-
Loading…
-
Loading…
-
Loading…
