-
-
gifbohane replied to the thread Fresh primer hits the ground, becomes a golden nugget search.Worried about a Small pistol primer going bang in a 223............... -
gifbohane replied to the thread Fresh primer hits the ground, becomes a golden nugget search.I hate when I find one cause now I do not know to what firearm it belongs and I have to toss it anyway.
-
gifbohane replied to the thread Just ordered bullets from Acme.I hope that I am not violating any policies here but I have to ask the OP. Have you tried Rocky Mountain Reloading?
-
gifbohane reacted to Rule3's post in the thread An unusual reloading setup? Single stage for sizing/decapping, RCBS Auto Prime, Dillon 5 stage to finish with
Like.
I get the pop corn first :) I think that I could size/decap a whole lot of brass in an evening and throw it in the ultrasonic cleaner... -
gifbohane replied to the thread help picking a press.Yep, a Rockchucker that you will leave to your heirs. I can make 300 in a few hours and I am not fast OR skilled I am a buy once, cry...
-
For guys who clean and polish brass with a tumbler with media- Which cover do you use? It came with two, one with many slits to drain...
-
I have a Lock & Load progressive, a T7 and a RCBS rock chucker. Plain ol' rock chucker was first. A few years ago I removed the 7/8"...
-
gifbohane replied to the thread help picking a press.T 7 buy once and cry once. I first bought a Rockchucker and it worked fine for my needs. Few years later bought the T7. Still...
-
gifbohane replied to the thread Colion Noir - NY Judge does not allow the 2nd Amendment in the courtroom?.It happened back in the 80's when the "Good People" elected a tax grifter Mayor of New York City
-
gifbohane replied to the thread I don't want a Sig P365. Tell me why I'm wrong or offer options..Bought an Equalizer and am happy with it. I tried it and the 365 and could not see any difference so I put a few hundred in my pocket...
-
gifbohane replied to the thread Lee's Factory Crimp Die?.I promised myself I would stay out of this topic forever.
-
Mos Most discussed, least important...
-
Anyone have a video on proper set up of Redding 223 deluxe dies, specifically the seating the die? Instructions that came with it are...
-
gifbohane replied to the thread Chamfering vs flaring/crimping for 9mm?.Interesting.... did not know that. What would be your choice for a 9MM die (decent/expensive one) that would not require belling? BTW...
-
The (should be) reason one chamfers a case is to remove the burr after trimming, it has nothing to do with bullet seating.
-
-
Loading…
-
Loading…
-
Loading…