Chuck R.
Latest activity Postings Images About
-
-
They made a third for Bergara. The Highlander uses a more traditional stock. I forget what it’s called, but they don’t make it... -
Chuck R. replied to the thread Grayboe Stocks, Opinions?.I couldn't find it either, so I just went off the picture: Looks like a slightly darker desert camo. From what I can gather, they...
-
Yes, they come out. I run mine through a Frankford media separater.
-
Chuck R. replied to the thread “New” old Colt 9mm AR.Why avoid coated bullets? I've shot thousands of them through my Colt? I normally just run whatever load I'm using in my IDPA gun...
-
Nearly everything on the planet is going up in price. The good news is, that's being offset by a reduction in life expectancy, keeping...
-
Chuck R. replied to the thread Grayboe Stocks, Opinions?.Thanks guys! I've got a Phoenix 2 in "Rim Country Camo" on the way. I did see that they made the Ridgeback stock for Bergara, they...
-
I have several and have been happy with them. For a while they supplied the stocks for Bergara rifles and that’s how I ran into them...
-
Chuck R. reacted to Varminterror's post in the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder) with
Like.
In general, virgin brass is annealed before it leaves factory. So I pull up the diameter, then push back down part of the neck, which... -
Chuck R. replied to the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder).Now that is a neat trick! I've been annealing 1st, why do you anneal after creating the false shoulder and sizing?? LCT??
-
Chuck R. reacted to Varminterror's post in the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder) with Like.
I wish folks would stop telling new reloaders to measure fired brass to set their sizing dies. So much headache would be averted. Your...
-
Chuck R. replied to the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder).That's exactly what I'm doing.. and becoming a freaking expert at Rem 700 "rapid bolt stripping and reassembly" while I'm at it.
-
Chuck R. reacted to jmorris's post in the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder) with Like.
Just keep your die high enough to not shove the shoulder back but low enough the neck is sized well enough to hold a bullet. At some...
-
Good to go. I had a Ridgeback for a short time just to test drive after a buddy test drove it. No complaints.
-
Yeah nitrided or chrome lining adds a lot round count to barrels.but 300 Bo is pretty slow and being 30cal without overbore it's going...
-
Chuck R. replied to the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder).and this is the crux of the issue right now..
-
-
Loading…
-
Loading…
-
Loading…