-
-
Kaldor replied to the thread Using Standard Small Pistol Primers with Ramshot Enforcer Powder.Personally, duplexing just isn't worth the risk and these are my thoughts. 100% case fill is mandatory as the powders will just blend... -
Kaldor reacted to Hooda Thunkit's post in the thread Using Standard Small Pistol Primers with Ramshot Enforcer Powder with
Like.
What you describe here is called "duplexing", or a duplex load. It is used to get a very slow powder started burning, almost always in... -
Kaldor reacted to FROGO207's post in the thread Using Standard Small Pistol Primers with Ramshot Enforcer Powder with Like.
FWIW I have standardized all my small primers to SRP for ease of inventory. I do have some SPP for a couple pistols that will not...
-
Kaldor reacted to AJC1's post in the thread Using Standard Small Pistol Primers with Ramshot Enforcer Powder with Like.
I have no reservations about building up a load with any primer. I've even run srp trying to get 4227 to burn good in 357. A mag...
-
Kaldor reacted to Crosshair's post in the thread Once fired .357 Brass costing almost as much as new Starline! with Like.
So I was putting together an order at Starline for some 357 Maximum and 327 Federal. (Backordered, but ill eventually get it.) I...
-
Kaldor replied to the thread Odd Annealing Question.1. Yes. I anneal every firing and tumbling removes any coloration. Some manufactures polish their bras, some dont. 2. All brass is...
-
You are going to like the ACME bullets. I like the way they come packaged. They've been very accurate and reliable in my S&W 929 and I...
-
Kaldor replied to the thread Just ordered bullets from Acme.Ive bought a ton of stuff from Acme over the years. They are about an hour from me, so its nice to support local. Never had an issue...
-
Like the title says, I just ordered 1500 bullets from Acme, 185gr swc sized at .452 for $175 plus shipping. Based on past experience...
-
Kaldor reacted to ericuda's post in the thread How to initially choose a powder when starting out? with Like.
Availability and versatility.
-
I just bought 8# of H4350 about 2 months ago. $100 down, and $100/mo for 36 months... just like a car.
-
Following to see what you end up with. I’ve loaded IMr 4895 and 4350 but with Nosler bullets and found decent loads. Nosler has some...
-
You can't go wrong with either powder. In my lifetime of hunting with a 30=06 my rifles never like high velocities. Groups would open...
-
Kaldor reacted to jmorris's post in the thread What's the use of 220 grain polymer coated bullets? with Like.
You could turn money into noise with them. If you buy a 300 blk, you could make even less noise with them...probably what they were...
-
Kaldor replied to the thread 9mm subsonic..3.2gr of TG or N320 is 980fps with 147 HiTek coated for me.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…