-
-
woodnbow reacted to earlthegoat2's post in the thread Importance of ‘BP load development’ to find the BEST group! with
Like.
Well I guess I am just lucky. First group (of 3 shots) with 100 gr 3F from this ASM Hawken .58 -
woodnbow reacted to Captain*kirk's post in the thread More reliable Remington or colt cast your vote n tell why with Like.
As far as cappers go...they are useless on a Remmy. Especially straight line cappers. I cap at the line using fingers and seat with a...
-
woodnbow reacted to Jackrabbit1957's post in the thread More reliable Remington or colt cast your vote n tell why with Like.
It's interesting about cappers being useless on a Remmy. I have a brass frame ASM that a capper works on and a Pietta that it won't...
-
A nearby dairy had (has) s huge problems with starlings roosting in the cow barns and causing considerable damage. I was invited to...
-
I’m sitting on probably 9 tins of Rem #10s but I don’t like these shortages we see periodically!
-
woodnbow replied to the thread stuck plunger.You may need either a bigger hammer or a cheater bar. 😎
-
woodnbow replied to the thread three questions.The great thing is, everyone can create their own secret recipe, possessing mystical powers! What could be better than this?
-
As I said to 38Special, if the lube is stiff enough to be rolled into pills, and pressed over the ball or bullet, it will stay in the...
-
Correct ball size, in which a minor ring is shaved when seated is the way to stop chain fires. As stated above, lube over ball creates...
-
woodnbow replied to the thread Cutting Aluminum Cans.PowderInc has them others do as well. Prices are higher than you are used to but welcome to Bidens world…
-
Thanks. Maybe half the price of a cheap one but that's not counting the propane. The blade isn't all that thick but it's sturdy. I've...
-
No. I used large cutoff wheels on a Dremel to cut it out while keeping it wet to keep the heat down. I'm not going to say how many...
-
My interpretation of a long hunter knife. I made it out of an old gang saw blade and it has some pitting but I like the look of it and...
-
woodnbow reacted to Jackrabbit1957's post in the thread More reliable Remington or colt cast your vote n tell why with Like.
I am considering offering opening up the nipple wells as part of the tuning/ repair service. What do you guys think?
-
woodnbow reacted to Doc Rizzi's post in the thread Smoothing the action. . . what you can't see with Like.
Tack Drivers I shoot CAS so when I practice I shoot from 15 out to 25 yards....and they are tack drivers. I can shoot two inch tight...
-
-
Loading…
-
Loading…
-
Loading…