4

41 Mag

Member From Texas - Born and Raised
Joined
Last seen
Messages
2,356
Reaction score
1,107
Points
113

Latest activity Postings Images About

    • 4
      41 Mag replied to the thread First run on new flame annealer.
      I found that for "06 sized cases and smaller one torch worked just fine. These are really a lice little package. The only issue I had...
    • 4
      41 Mag reacted to Big Bore TX's post in the thread .41 Mag Association with Like Like.
      A few updates to my latest 41. I made the grips from walnut, and these were my second attempt. The first set were from micarta and quite...
    • 4
      41 Mag replied to the thread Sierra TGK Gamechangers.
      I normally just run the Hoenady 140gr spire points in my 260, but I did pick up a couple boxes of the Gamechangers last summer. I got as...
    • 4
      41 Mag replied to the thread So, You Want To Start Casting…?.
      I have been casting for just over a decade. It is hard to put much more into this than what Bearded Phil and the others have mentioned...
    • 4
      41 Mag replied to the thread Beware of Vihtavuori Load Data..
      SO sometimes tighter tolerances, lead bullets, tighter crimps can all influence how some powders perform. Lead bullets for example will...
    • 4
      41 Mag replied to the thread 30-06 powders?.
      About 56-57 or so grains of 4350, pick one, with 150-165gr bullets has been a stable load for me for nearly 40yrs. It just seems to...
    • 4
      41 Mag reacted to Charlie98's post in the thread 30-06 powders? with Like Like.
      I just bought 8# of H4350 about 2 months ago. $100 down, and $100/mo for 36 months... just like a car.
    • 4
      41 Mag replied to the thread 30-06 powders?.
      Ain't that tha truth... :rofl:
    • 4
      41 Mag replied to the thread Terminal performance comparison.
      Yeah, ya gotta be careful about that. Usually when I "recycle" the ones recovered at the range berms, and outta the pasture, I put a...
    • 4
      41 Mag replied to the thread Terminal performance comparison.
      So I will play along with my little bit of who do voodoo.. When I began casting my initial bullets were the wide flat nose type, mainly...
    • 4
      41 Mag replied to the thread Light 45 Colt loads.
      Might look into something similar to this, .45 Express-Grooveless Since your looking for something lightly loaded you could roll crimp...
    • 4
      41 Mag replied to the thread Zen and the art of reloading.
      WEll I would say that hand loading IS VERY therapeutic, in fact old the oldest grandson that yesterday. My problem is, I got to a point...
    • 4
      41 Mag replied to the thread Powder prices.
      I can probably get buy on what little selection I have on hand. I about choked on my coffee the other morning when I saw what SW...
    • 4
      41 Mag replied to the thread 360 BuckHammer first loads....
      It is a Henry, the one on the left. Since that pic I've added the same Leupold Freedom 1.5x20 with MOA as is mounted on the 44 to the...
    • 4
      41 Mag reacted to Bearded Phil's post in the thread NOE Cast Bullets in Henry .44 Mag Rifles with Like Like.
      A lot of guys say 2 coats is fine for them but I like to do 3 total. 3 for me gives the most uniform total coverage and helps minimize...
    Show older items
  • Loading…
  • Loading…
  • Loading…
Back
Top