BBBBill
Latest activity Postings Images About
-
-
BBBBill reacted to Armorer 101's post in the thread What gunsmithing or repairs have you done today with
Like.
I am building a 358 Win Conversion on a M-96 1943 Husky action, arsenal new, never fitted to a barrel. So far I have the action trued... -
BBBBill replied to the thread Beretta Tomcat Safety Lever Mod.A perfectly acceptable mod. I've done similar on 1911s and S&W 3rd gen guns. In fact S&W did that from the factory on some of the...
-
Hi folks, perhaps there are others who experienced something similar to me with their own Beretta Tomcat 3032 or even the new Tomcat...
-
I don't have the experience of many of those who have commented thus far, but here's my list: 1. Improper use of cleaning products...
-
BBBBill reacted to dfariswheel's post in the thread How does improper cleaning ruin a barrel? with Like.
Among the ways cleaning can damage a barrel is using "expedient" cleaning methods and materials. You always hear about people using some...
-
BBBBill reacted to CapnMac's post in the thread How does improper cleaning ruin a barrel? with Like.
Further, not letting a bunch of bored troopies in Boot Camp use steel rods down the barrel, 2x or 3x per day, to keep them busy will...
-
I have been using Timney Triggers for over 50 years and never had a problem with one until this past month. I currently own 8 Model 70...
-
It came off. With the help of a pair of vice grips and 2 pieces brass from a .44 shell.And an idea from y'all. Thanks.
-
BBBBill replied to the thread Should be simple.To avoid crushing the lug/stud put a screw in the hole.
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
...........
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
This is a full-circle Sig P6 story. I acquired both a Sig P225 and its specialty variant the P6 in pristine form many years ago. The P6...
-
BBBBill reacted to Armorer 101's post in the thread Reboring a 22 for a Liner - What Do I Need To Know? with Like.
Bore the hole straight through with an extension on the liner drill, in a lathe. Do not drill it by hand, nor from each end. Start at...
-
I bet it does. I have a gauge to specifically check that gas key - lower receiver ring gap tolerances. A fancy two quarter test. There...
-
BBBBill reacted to Armorer 101's post in the thread What gunsmithing or repairs have you done today with Like.
Did some sanding on the new stock for the 358 Win conversion. Have the metal work done, inletting and glass bedding done, just need to...
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
.........
-
-
Loading…
-
Loading…
-
Loading…