Doublehelix
Member
- Joined
- Nov 7, 2016
- Messages
- 1,059
They may also have issues dealing with low, low loads like 0.2 gr. I realize the spec may be +/- 0.1 gr., but that spec is probably only applicable at "normal levels". I know that some of the electronic scales are not as accurate as the very low weights, lower than what is considered normal operating levels.
If you did what was suggested above by NeuseRvrRat in post #17, this might be a good test to verify that.
If you did what was suggested above by NeuseRvrRat in post #17, this might be a good test to verify that.