Down Range
Member
- Joined
- Aug 3, 2019
- Messages
- 15
I have issued with my RCBS powder dropper. When I use powder like H110 or 2400 my powder dropper gets powder built up in the dropper I can hardly cycle the handle up and down. Any ideas?
Perhaps a picture would do, because I can't imagine what you're trying to explain here.. . . my powder dropper gets powder built up in the dropper I can hardly cycle the handle up and down.
The handle will hardly cycle up and down. I take it apart, clean everything and I'm good for around 50 cycles then it locks up again.Perhaps a picture would do, because I can't imagine what you're trying to explain here.
If more than a fine layer of H110 is sticking somewhere, I suspect contamination of the surface. Wipe it down with a paper towel, wipe it down again with a dryer sheet, and it should throw anything.
I've had that issue with lesser (Lee) measures, but my Uniflow doesn't pass grains into the gap.The handle will hardly cycle up and down. I take it apart, clean everything and I'm good for around 50 cycles then it locks up again.