-
-
Eedwardware replied to the thread Sprindfield XD Remover rear sight.I offer you the gunsmith's sight pusher for Kimbers. . . Link
-
Eedwardware replied to the thread Sprindfield XD Remover rear sight.Measure the dovetail notch. If it's tapered, the sight will drive out the wider end.
-
Eedwardware reacted to Rule3's post in the thread Trying to decide on only one bullet for 357 with
Like.
158 lswc poly coated What the caliber was designed for -
EJust reading the title from the front page summary. I am thinking a new gun company/ gun dropped I hadn’t heard of. :rofl::rofl:
-
EOh, and I forgot to mention. The answer is almost never "more crimp." More crimp is almost always a bad thing. Especially with plated...
-
Eedwardware replied to the thread What am I doing wrong?.Right here: COAL is set to plunk, not to the manual. And not to a chamber gauge either, unless it's the chamber gauge installed on...
-
EA question better asked here than of the EPA. The answer is “discretely”.
-
Eedwardware replied to the thread Used Walnut and Corn Media??.I load .45 Colt shot shells, and kill carpenter bees, hornets, and wasps. . .
-
Eedwardware reacted to Laphroaig's post in the thread M855A1 projectiles.......cores spin? with Like.
M855's are not known as accurate projectiles. Maybe the loose tip is a reason, or maybe there are other factors. I doubt if its worth...
-
E20% minimum, more for exceptional service.
-
EMy thoughts? Find a platform better suited for a lefty, and stop trying to force a round peg into a square hole. If it's not a defensive...
-
ENo. Just no.
-
Eedwardware reacted to Dave DeLaurant's post in the thread Jeez Louise, all I want is one hex bolt! with Like.
BTW, on the general subject of fastener questing, I did a fair bit of rummaging through drawers and trawling online to find a suitable...
-
Eedwardware reacted to tomtomgt356's post in the thread GA: Proposed law to make owners of gun free zones liable with Like.
GA: Bill Would Make Property Owners Liable For Injuries In Gun-Free Zones - The Truth About Guns A bill introduced in Georgia would hold...
-
Eedwardware reacted to derek45's post in the thread Mini14 fails to pick up round from magazine with Like.
Yes, the action is properly lubed. I also think it may be over gassed so much that the bolt is moving forward faster than the magazine...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…