The Glockodile
Member
- Joined
- May 6, 2020
- Messages
- 1,688
I’ve just finished my first 3000 rounds of 9mm using range pick - up brass, using up 200 to 300 each range session, and have been lucky to have no “assembly” failures thus far beyond the first ten dummy rounds (implying that a sample size of 3000 is too small to generate enough significant fliers in the bell curve).
Reloading was done on a Forster Co - Ax, a single - stage press.
Expander mandrels were used to very slightly flare the case lips prior to seating the bullets.
Crimping was never performed.
Reloading was done on a Forster Co - Ax, a single - stage press.
Expander mandrels were used to very slightly flare the case lips prior to seating the bullets.
Crimping was never performed.
Last edited: