Got it, only reason I asked is because I have seen factory loads look similar to this due to carbine gas system over gassing due to gas port being too large and unlocking too early but no ejector extrusion or swipe primer nice and round. Case looked rough and rim was bent with extractor claw marks under it because of the over gassing. with the case still under higher pressure it was still pressed tight in the chamber. Adjustable gas block “fixed” the issue. Only reason I brought it up was because until the over gassing situation was taken care of the brass looked very similar to this photo.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.