BBBBill's latest activity
-
BBBBill reacted to Twocanary's post in the thread Finish peeled off a Huglu side by side by just looking at it wrong, hehe with
Like.
The wife is petite so needed to shorten the butt stock and fit a recoil pad. Thought learning to diy would be a good skill set to have... -
BBBBill reacted to a5werkes's post in the thread How can I remove an invector plus choke that won’t budge? Tried a lot of tool but still no deal. Any solvent ideas that could help? Need a miracle . with Like.
I would use a universal choke tube magna tip or a hollow ground driver bit (both with hex head drives) mounted in a cordless impact...
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
........
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
Tinkering in the shop yesterday. Years ago I fabricated some arbors, long and short, for using Dremel tool accessories in cordless /...
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
So, I was pondering the the manner in which to de-burr that #53 cross-drill hole (0.052") in the #4 screw. The smallest reamer I have is...
-
BBBBill reacted to Freudianfloyd's post in the thread What gunsmithing or repairs have you done today with Like.
A while back I picked up a Savage 1907 from a yard sale. Whoever the previous owner was thought that it needed to be spray painted...
-
BBBBill reacted to a2x4bbl's post in the thread What gunsmithing or repairs have you done today with Like.
Ready for test fire . Then final sanding ( lots of sanding ) before off for some kind of finish . Trigger came out at a little under 3 lbs .
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
When removing the ejector rod from the cylinder on the M49 I used my old laminated wood- leather vise jaw inserts. The wood backing...
-
BBBBill reacted to troy fairweather's post in the thread What gunsmithing or repairs have you done today with Like.
The bolt handle on the classic m70 is shaped different from the pre 64 bolts, since I'm going to camo the stock I filled the gap with jb...
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
......... that's all I have for TGIF.
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
.........
-
BBBBill reacted to a5werkes's post in the thread What gunsmithing or repairs have you done today with Like.
I had some time to check-under-the-hood of the "new" 1971 S&W Model 49 to see what 50+ years of aging lubrication looks like. No...
-
I believe I have every imaginable tool and bit to remove gunsmith sized screws and employ all the usual tricks to remove the difficult...
-
BBBBill replied to the thread 30-06 to 404 Jeffery.A Square. Brainchild of Arthur Alphin.
-
BBBBill replied to the thread Is Part Of My AR Gas System Worn Out?.Gas port in the barrel can wear, too. If it gets bad enough you WILL have cycling problems.