I bought one of the RIA .22TCM bolt action rifles not too long after they came out. The rifle had a terribly rough bore (machine chatter marks) so I sent it back to RIA in Nevada & they sent a replacement out. The second rifle was just as bad, if not worse, than the first so I returned it also &...
A little late to this discussion, but I picked up a 15-4 at a local gun show last weekend. Although I had some money in my pocket, I wasn't looking for anything in particular but have been toying with retiring my c.1927 Colt Officers Target .38 due to a crack in the forcing cone. An older...
My friend has bought a few antique collector's guns from them & has been well pleased. He always waits for the twice a year sale though, as they tend to be pretty high with their prices.
I have a commercial Webley Mk.V with the six inch barrel, in .455 Mk.II. I cast a lot of bullets for my old British rifles &, even though I have a mold for the .455, I chose to buy bullets for the Webley from Bear Creek Supply in Waterford, CA. They do a 260gn HBRN bullet that shoots as well, or...
I'm hoping to find a .316" sizing die to fit my RCBS Lube-Sizer, that size doesn't seem to be offered by RCBS or Lyman. Any ideas on where I might find one or get one made?
My friends in Australia told me that when their Government was doing the 'Buyback' in 1995(?) they were often paying prices much higher than market value. If a value was considered too low a number of selected people in the firearms trade were consulted to ascertain a correct amount.....this...
Not quite correct, MLAIC competition does not allow for wiping between shots in events for military arms, or at least they didn't when I was on the USIMLT from 1999 thru 2009.
The Zoli-made Zouaves use the correct US musket nipple thread of 5/16x24. If a nipple flange sits too high insert a copper washer between the nipple & bolster.
I think the suggestion was to use a drilled out nipple in conjunction with a hose attached, so that the water in a bucket can be pumped back & forth through tbe barrel. Uncle Mike's used to make a barrel flushing kit that was essentially a drilled out nipple, a rubber o-ring & a length of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.