I messed around with stuff today a bit.
I turned the die down about 1 more full turn in the press and sized some brass. The cam over was pretty hard but I was getting consistent .002-.003 shoulder bump. I’m going to take the die to work and take about .010 off the base in one of the lathes...
Steve - the AP is my only press at this time.
Jim - all of the rounds I’ve made to this point have chambered without issue and pass the case gauge no problem. I got the headspace gauge thinking that I could be overworking the brass and wanted to see if I could use this tool to help extend...
I’ve been reloading .223 for a little bit now with no issue. I finally broke down and bought a Hornady headspace gauge to check my shoulder bump. I’ve been using a Dillion case gauge to check rounds with no issue but I went through and sized a few rounds that I fired from my AR (PMC and LC...
I've been eyeballing this unit. Looks pretty solid and seems to work with all the standard bullet feeder dies.
http://socalsw.com/Mag-P-Large-40-cal-45ACP_p_30.html
Put extra packing in the box when you sell me the case feeder for the LNL? :rofl:
While my LNL hangs up empty cases on the ejection nub from time to time, as long as I do my part with full strokes of the handle, it always indexes correctly and primes.
Congrats on the purchase of the 650.
Looking at a bullet feeder for the LNL and ran across this site. http://socalsw.com/
Basically has 2 options, one is an adapter to use the Lee multi-tube bullet feeder on top of the hornady bullet die or use his custom feeder which is like the Lee only bigger for more capacity.
Anyone here...
I like that idea a lot. Especially since in the new house I build in a few years SWMBO has already Ok'd a dedicated room in the house for the reloading/gun room instead of it being out in the shop. I just need to come up with a decent design on cabinets/bench that I can store everything neatly...
The green handle ones are the ones I currently use. I have 3 of the largest ones they make for .223, 9mm and .45 that are full with an additional 5 gallons of 9mm needing to be cleaned and processed. I may get some 15 gallon barrels (guy sells metals ones locally on CL for 10 bucks with a lid...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.