We tried 20.5 of the 2400 with a Hornady FTX 225 Grain, it was bad.
Also tried a 240 Grain JHP with 19.0 grains of 2400, still stunk.
Looking into trying some H110....
Anybody got some suggestions?
THANKS for any help!!!
Glennster is online now Add to Glennster's Reputation Report Post...
I have some Peltor 6, they are low profile, that's nice, but I've sent 2 pair back to be replaced. I hear that their more expensive electronic muffs are more reliable. The big bulky muffs can be a problem in some cases....
I put a Ciener 22 conversion on top of an STI 1911 Lower. There seems to be too much resistance as the slide comes back. This is causing some jams......
Most of the friction / resistance comes from the bottom of the slide as it hits the hammer and pushes it down. I was going to grind a...
I'm about to own my first HK 91, I have a pile of 308 brass that I can load. So I'm looking for a GOOD recipe for this rifle.
THANK YOU for any help!!!
I've got an old Browning Hi Power with an adjustable rear sight, the screw on the left side came up missing.
Where is a good place to get one?
THANKS for any help!!!
The guy selling it says it's a 38, I have plenty of 6.5 bullets for my 6.5/284. Would the ballistics on the 6.5 Jap be about the same, I run 2950 fps...
I'm looking at buying an Arisaka 6.5 that's been sporterized. I'm concerned about a few things, I hear that the early Jap rifles (barrels) where made with high quality steel and that the later rifles were questionable. How can I determine if it's a high quality model or early model?
This...
PapaG,
When you say 2400 didn't work well, what specifically do you mean? Accuracy?
I shot some test rounds as described above, they were grouping well, but the cases had black burn marks on them and there seemed to be a lot of residue left in the case, kind of like unburned powder. It's a...
I'm just getting into loading the 44 Mag, I'm loading some light loads for fun plinking (12 Gr. of 2400 behind 220 Gr. Berry Plated bullet), but also want to load some hot stuff for the rookies that want to get hammered by the force of the 44 Magnum....
How hot can I safely load the 220 grain...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.